Concrete Resurfacing
Worn, stained, or mismatched concrete brought back to one clean, sealed surface — speckled, flaked, or solid, with borders if you want them.
What it is
Resurfacing is the answer when concrete is sound underneath but the surface has given up: spalling, staining, patchwork from an addition, or a texture someone applied years ago that has worn through in the traffic lanes. Rather than trying to spot-repair into an existing finish, we take the whole area back and put down one consistent surface.
That is a deliberate policy, not an upsell. Matching an existing texture or colour that we did not install almost never works — the patch reads as a patch under Florida sun, and it looks worse than leaving it alone. The honest options are to resurface the whole area or to leave it, and we will say which we think is right.
Finishes range from a simple speckled texture through flake broadcast to a full stamped overlay. Speckle with a single border is our most-requested driveway finish because it hides everyday dirt, costs less than stamping, and still looks deliberate rather than utilitarian.
Where it's best
- Spalled, stained, or sun-bleached driveways and patios
- Concrete patched from an addition, pool cage, or plumbing repair
- Old coatings or textures that have worn through in traffic lanes
- Pool decks and lanais needing a fresh, UV-stable, slip-resistant surface
How we install it
Concrete Resurfacing goes down in four stages, always in this order, and each one gets the cure time the manufacturer specifies rather than the time a schedule would prefer. Compressing or skipping a stage is the single most common reason a coating fails early, so the sequence below is the job — not a summary of it.
-
Grind
The full area is diamond-ground to remove the failed surface, old coatings, and staining, and to open a profile the new material can bond to.
-
Repair
Cracks, spalls, and pitting are cut out and filled. Repairs are always bid and photographed rather than absorbed silently into the price.
-
Resurface
The chosen finish goes down across the whole area in one operation — speckled texture, flake broadcast, or a stamped overlay — so there is no seam between old and new.
-
Border and seal
Optional borders are cut and coloured, then the surface is sealed with a UV-stable finish at the slip level the space needs.
Frequently asked questions
Can you just fix the bad section?
How much does resurfacing cost?
Will it hold up to Florida sun and rain?
Other systems
Want Concrete Resurfacing on your floor?
Get a free, no-pressure quote — send a couple of photos and we'll tell you exactly what your slab needs.